PVC Wavy Board & Trapezoidal Board Production Line
1. Machine Features:
The production line consists of conical twin screw extruder and corresponding wavy board forming machine, haul-off unit and cutting unit. The production line can continuously produce UPVC colorful, season resistance and inflaming retarding wavy board used in buildings. The SJSZ65/132 conical twin screw extruder is available to produce relatively smaller size wavy board, while SJSZ80/156 conical twin screw extruder is good choice to produce large board.
This line has the characteristics of stable plasticization, compact structure, and high automation and easy to operate, etc, it is a perfect choice for manufacturers.
2. Technical Parameters:
|Die||T-type flat mould L=1000mm||Size of cooling mould
|Forming machine||Cooling mode: by water||Cutting mode: Sheer type
( pneumatic control)
|Big wave||R=15 H=16.5
Pitch of waves 63mm
|Haul-off speed: 0.5-5m/min||Cutting follow-up
|Small wave||R=9 H=8
Pitch of waves 36mm
|Haul-off roller: 1000mm||Pneumatic pressure:
3. Features of PVC Wave Board/Tile
PVC wave board is also called as PVC corrugated tile, or roofing tile, have the following features:
High efficiency heat insulation and sound insulation; resisting leakage, wind and impact; excellent corrosion-resisting performance; good fire resistance; High utilization ratio, green environment-friendly; quick installation.
Specification of Wave Boards:
Length: according to the customers’ need
Color: green, blue, gray, red, yellow, brown.
Type: corrugated type, trapezoidal type
4. Application range of roofing tile:
PVC corrugated tile is high-end roof material mainly used in high-class factory building, steel structure factory building. Warehouse, open fair, market passageway, care shed as well as balcony, heat protection shelter with certain heat protection requirements
5. Notice of installation requirements:
Please use a fine-toothed saw to cut PVC, can drill with hand drill or power drill. When drilling, the bottom should be supported to prevent swaying, and the whole diameter should be bigger than screw by 50%. When fixing screws, special rubber mat should be placed under the tile, and the screws should be properly fasten and should not be too tight.
The frame structure uses structural steel or wood as purlines, requiring neat, parallel and evenly spaced pralines without deforming.